Troubleshooting: updates and maintenance
The software update failed
When an update fails, the device has already restored automatically to the version before the update; images, schedules and settings are not affected.
- Check in Device info that the version is back to the one before the update, and read the reason for the failure shown on the result screen.
- Download the update file again from the Downloads page (the file may not have downloaded completely).
- Check that storage is not over 90% and that the device has stable power.
- Move close to the device and try again where the signal is good.
- If it still fails, note the current version, the version you're updating to and when it failed, and contact technical support.
If the update is rejected before installation starts (for example, there isn't enough storage or the current version is too old), the result screen shows "Update Failed" and the reason right away, and nothing on the device has been changed. See Software update — Update result.
"Start Update" stays gray
If no version preview appears after you choose a file, and "This file is not a valid update package. Please check that the download is complete" or "The update package is larger than 128 MB and cannot be used" appears, the system can't read this update package:
| Possible cause | Fix |
|---|---|
| The file you chose isn't an OTA update package | Check that the file name is chlcd-update-v<version>.tar.gz |
| The file didn't download completely | Download it again |
| The browser unzipped the file automatically (Safari on Mac) | Turn off Safari's "Open 'safe' files after downloading", or download with Chrome instead |
| The connection was lost during upload | Move closer to the device and choose the file again |
"Connection Timed Out" during the update
If the result still can't be confirmed after more than 5 minutes:
- Check that your phone is still connected to the device's Wi-Fi.
- Refresh the page and check the software version in Device info:
- It's the new version → the update succeeded.
- It's still the old version → the update didn't happen, or it was restored automatically.
- Devices below version 1.6.5 can't be upgraded directly and stay on their current version. Install the 1.6.5 update file first, then the latest version; see Download updates.
The management interface behaves oddly after the update
Refresh the page. If there's still a problem, close the tab and open it again; see Connection and management interface — page errors after a software update.
The factory reset button can't be pressed
You must type confirm in lowercase (with no spaces) in the box for the button to become active. The border turns red if you type it wrong.
A factory reset was triggered by accident
Holding any physical button for 40 seconds triggers a factory reset:
- When the status LED starts blinking fast (after holding for 3 seconds), release immediately to cancel.
- Once it has been triggered (LED steady on), it can't be canceled. When it's done, correct the time again, upload images, and create image sets and schedules again.
- If it's triggered by accident often, check whether something is pressing on the button, or whether the device is mounted where the button is easily bumped.
See Factory reset.
Can't connect to the original hotspot after a factory reset?
This is normal. A factory reset returns the hotspot name and password to this device's factory values and deletes the Wi-Fi networks added by users; the time zone and time, and the model, are kept. If the hotspot was changed earlier under "Network", connect to the factory hotspot instead; see Factory reset — The hotspot password returns to the factory password.
Running out of storage
Storage in Device info turns red when it's over 90%. Low storage can cause uploads, refreshes and software updates to fail.
- Go to the image gallery and delete images you no longer use (download the originals of any you need to keep first).
- Go to System logs and clean up expired logs (download the full logs first if you need to keep them).
- If there still isn't enough space, contact technical support.
The display is wrong after a Tcon firmware update
Contact technical support right away and give them the firmware version numbers from before and after the update. Don't try other firmware files yourself.
Related: Software update, Factory reset, Device info and monitoring